Glass Door Tint Glue Remover

Removing the old adhesive is actually a simple process.

Glass door tint glue remover.

The wider the blade the more efficiently it will strip the plastic from the window. Preparing the glass tinting film can be removed with a properly sharpened razor blade. So i was sure i would find a simple and easy way to do this but if you don t want to remove your door panels then a new razor and 409 simple green or windex. Wipe the door panels or window frame with a clean microfiber cloth to remove any water from the steaming process.

Peanut butter as a goo gunk remover. Spray it on and scrub the glue spots with a non scratch pad then dry the glass with a paper towel. The natural peanut oils present in peanut butter help break down the adhesive bond present in glue. Old style tint adhesive that used to turn purple and bubble off the glass has been replaced with longer lasting films.

After a few seconds gently apply pulling pressure on the film. If the glue has dissolved some film will come off. Spray glass cleaner onto the surface of the glass and clean it thoroughly with a paper towel. This is especially true when it comes to removing stickers from the glass.

The following is a quick summary of stripping tint film from a glass door. Step 2 wipe with solvent. After peeling the sticker off adhesive and glue marks are left behind which can be a struggle to clean especially if the residue is sticky or greasy. Grasp the film where it has already come loose from the glass and spray some of your soapy water mixture behind it.

To make the process much simpler apply two things to your window before you begin. Window tint has evolved and replacing old tint adhesive is a common automotive repair. Use new 0000 steel wool rub lightly in warm soapy solution to remove it. Toohui car sticker remover blade window tint remover utility knife for film glue removing window film tool stainless retractable razor with 20 blades 5 0 out of 5 stars 3 7 99 7.

Take your solvent of choice nail polish remover lighter fluid acetone or even engine penetrating oil and soak a paper towel in it. Dish detergent or liquid car wash are both good ideas for this part of the project. Once the window tint is removed some original adhesive may remain. Peanut butter works better than you d think as a gunk remover since it acts as a diy goo remover for almost all residue left behind by duct tape on glass containers and other surfaces.

Step 1 clean the glass. That will start dissolving the glue and loosen its hold on the glass. It just takes time and patience.